Ruth Hickey New Zealand Based Independent Stampin' Up!® Demonstrator
Mobile 027 844 1611

Quick Cards with a Wow! Factor using Adhesive Sheets

Comments are off for this post.

Making quick cards is easy with Multipurpose Adhesive Sheets. In minutes you can create a stylish card with the Big Shot, dies and adhesive sheets. Use Foil Sheets or Glimmer Paper for the Wow! factor, the instant bling is most noticeably when you use large dies. The Adhesive Sheets save you a lot of time when using detailed dies that you would otherwise adhere with the Fine Tip Glue Pen.

Quick Cards using Adhesive Sheet

The quick cards below where created using the Happy Birthday Thinlit and Multipurpose Adhesive Sheets. The first card is an A5 card base in Basic Black cardstock with the Happy Birthday phrase die cut in Gold Foil that has a piece of adhesive sheet stuck to the back before putting the foil and thinlit through the Big Shot. The measurement for the foil and sheet is the same 9 cm x 8 cm (3-1/2″ x 3-1/8″). Peel off one of the backing layers and attach it to the back piece of card or paper you are going to cut out. Cut out your shape or phrase and then peel off the other piece of backing and attach to your card layer or base.

Easy Birthday Quick Card

Card 1

Quick Card with DSP

Card 2

 

Supplies and Instructions for making Card Two

Paper:
Gold Foil (132622) 9 cm x 8 cm (3-1/2″ x 3-1/8″)
Very Vanilla Thick Cardstock (144238) 21 cm x 14.8 cm (8-1/4″ x 5-7/8″)
Bundle of Love Specialty Designer Series Paper (144143) 10.5 cm x 3.5 cm (4-1/8″ x 1-3/8″) gold foil splodge design or other gold foil design.

Accessories:
Multipurpose Adhesive Sheet (144106) 9 cm x 8 cm (3-1/2″ x 3-1/8″)
SNAIL Adhesive (104332)
Happy Birthday Thinlit (143700)
Big Shot Die-Cutting Machine (143263)

Accessories:
Multipurpose Adhesive Sheet (144106) 9 cm x 8 cm (3-1/2″ x 3-1/8″)
SNAIL Adhesive (104332)
Happy Birthday Thinlit (143700)
Big Shot Die-Cutting Machine (143263)

INSTRUCTIONS
1. Score Very Vanilla thick cardstock at 10.5 cm (4-1/8″) and fold to create card base.
2. Adhere DSP to the top and bottom on the front of the card.
3. Remove backing sheet of multipurpose adhesive sheet and adhere to Gold Foil.
4. Put gold foil through the Big Shot with the Happy Birthday Thinlit.
5. Remove the backing from the Happy Birthday cut out and place in the middle of your card.
6. Finished. Try other combinations of DSP and Happy Birthday cut out or just the Happy Birthday cut out on a card base.

Share this article

Comments are closed.